Updated November 2026

Laminate flooring cleaning with Bona is straightforward once you know which product suits your floor and how much liquid to use. This guide walks you through sweeping, damp mopping and spot treatment so your floor looks clean without streaks, residue or swollen seams. Most of the work takes about 15 minutes for an average room.

Check Your Floor and Gather Supplies

Before you clean, confirm that your laminate has a protective wear layer and that the manufacturer doesn’t restrict cleaning products. Many owners find their flooring’s care card or the brand’s website lists approved cleaners. If you’re unsure which type of laminate you have, see Wooden Laminate Flooring Identification: How to Tell What You Have for help.

Shopping for one? See our guide: 7 Best Laminate Flooring Installation Tools for DIY Renovators (2026).

Gather the following before you start:

  • A soft-bristle broom, dust mop or vacuum with a hard-floor setting and no beater bar
  • A microfiber mop with a washable pad
  • Two buckets, one for cleaning solution and one for rinse water
  • Bona laminate floor cleaner (a spray or concentrate made for laminate)
  • A dry microfiber cloth for spills and edges

Step-by-Step: Dry Clean First, Then Damp Mop

Remove Loose Dirt

Sweep or vacuum the entire floor before adding any liquid. Grit left on the surface acts like sandpaper under a wet mop and can dull the finish over time. Pay attention to corners and the gaps along baseboards, where debris collects.

Mix the Cleaning Solution

Follow the dilution directions on the Bona label. Using too much cleaner leaves a film, while too little won’t lift grime. Pour your solution into one bucket and keep plain water in the second.

Mop in Small Sections

Wring the microfiber mop until it is barely damp. Excess water can seep between boards and cause the core to swell. Work in sections about 3 feet wide, moving with the grain of the planks. Rinse the mop pad in the water bucket frequently, and switch to a clean pad when the first one looks gray.

Dry the Floor

Go over the cleaned area with a dry microfiber cloth to pick up any standing moisture. Most rooms are dry to the touch within a few minutes, which keeps seams tight and the surface streak-free.

Handling Stains and Buildup

For sticky spots or scuffs, spray a small amount of cleaner directly onto a cloth, not the floor, and rub gently. If a mark remains, let the product sit for a minute and wipe again. Avoid steel wool, abrasive scrubbers and scouring powders, as they scratch the wear layer.

Heavy grease or residue from old wax can build up over years. If you’re dealing with a large problem area, check the manufacturer’s guidance first. For background on how moisture affects different floor types, Laminate vs Vinyl Flooring compares how each material handles water.

Task Frequency Tool
Sweep or vacuum Several times a week Soft broom or vacuum
Damp mop with cleaner Every 1 to 2 weeks Microfiber mop
Spot clean spills As needed Dry microfiber cloth
  • Bona laminate floor cleaner is formulated for laminate surfaces and leaves little residue when used at the recommended dilution. View on Amazon
  • Bona microfiber mop kit gives you a mop head and washable pads that pick up dust and dirt without soaking the floor. View on Amazon
  • Soft microfiber cloths are useful for drying the floor and buffing away streaks at the end of each session. View on Amazon

Common Mistakes

  • Using a steam mop, which pushes heat and moisture into seams.
  • Pouring cleaner straight onto the floor instead of diluting it first.
  • Letting pooled water sit on the surface, especially near edges.
  • Skipping the dry sweep, which spreads grit across the floor.
  • Using vinegar, ammonia or oil soap, which can dull or leave a film on laminate.

FAQ

Can I use Bona on all types of laminate flooring?

Bona makes products for laminate, but you should always check your flooring manufacturer’s care instructions to confirm approved cleaners. Some warranties specify exactly what can be used. Worth reading next: Best Cleaning for Laminate Flooring: A Step-by-Step Guide for Beginners.

How often should I mop laminate floors?

Most households damp mop every one to two weeks, with sweeping or vacuuming more often. High-traffic areas may need more frequent attention.

Why does my laminate look streaky after cleaning?

Streaks usually come from too much cleaner or a mop pad that is too wet. Dilute the solution more, wring the mop well and dry the floor with a clean microfiber cloth.

Conclusion

Cleaning laminate with Bona comes down to three habits: dry sweep first, mop with a lightly damp pad, and dry as you go. Follow these steps every week or two and your floor will stay bright and protected. If you’re ever unsure about a stain or a warranty requirement, consult the flooring manufacturer or a flooring professional before trying a new method.

Owen Palmer

About Owen Palmer

Owen Palmer is part of our editorial team and reviews and edits our DIY home renovation guides, checking product details against manufacturer specifications and owner feedback.