Updated November 2026
A laminate flooring cutting tool lets you trim planks to length, rip them to width and fit them around doorways and cabinets without chipped edges or wasted boards. Most DIY installs need only one or two tools, and the right choice depends on how many cuts you make and how clean the finish needs to be. This guide covers the main options and how to use them.
Choose the Right Type of Cutter
Three tools handle most laminate work. Each one suits a different kind of cut.
Shopping for one? See our guide: 7 Best Laminate Flooring Installation Tools for DIY Renovators (2026).
- Fine-tooth handsaw or jigsaw: Good for short notches around pipes and door casings. A jigsaw with a fine-tooth blade works well, but cut from the decorative (top) face down to reduce chipping.
- Circular saw with a laminate or finish blade: Fast for long straight rips. Use a blade with 60 or more teeth and clamp the plank so it cannot shift.
- Manual laminate cutter (score-and-snap): A scoring tool with a carbide wheel or blade. Score the top surface, then snap the plank over a straight edge. Best for straight cuts on thin planks with no need for curves.
Step-by-Step: Making a Clean Cut
Whatever tool you pick, the process is similar. Measure twice, mark on the decorative face with a pencil, and leave a small gap at walls for expansion.
- Lay the plank decorative side up on a stable support, with the cut line over the edge of the support or a sacrificial board.
- For a score-and-snap cut, run the scoring tool along the line three or four times, applying steady pressure.
- Snap the plank sharply downward. Check the edge and rub it lightly with a file if needed.
- For a saw cut, mask the line with painter’s tape, cut slowly and let the blade do the work.
- Dry-fit the piece before you glue or click it into place.
Planning Cuts to Reduce Waste
Lay out your full room before you start cutting. Work from the longest wall, and plan the last row so it is at least 2 inches wide. Save offcuts longer than about 12 inches, since they can start the next row. Most installers keep a few spare planks from the same batch for future repairs, because color can vary slightly between production runs.
Recommended gear
- Manual laminate cutter: Makes straight, chip-free cuts without power tools or dust. View on Amazon
- Fine-tooth jigsaw blades for laminate: Reduce tearout on the decorative face when you need curves or notches. View on Amazon
- Painter’s tape: Protects the surface along the cut line and helps keep the edge clean. View on Amazon
Common Mistakes
- Cutting from the back face, which causes chipping on the visible side.
- Skipping the expansion gap at walls, which can cause buckling later.
- Using a dull blade. Replace it once it starts to burn or tear the edge.
- Forcing a snap cut on a thick or very hard plank. Switch to a saw instead.
- Cutting without checking the tongue and groove, which can leave a plank that will not lock.
FAQ
Can I cut laminate flooring with a utility knife?
A utility knife only scores the surface and cannot cut through the core. Score repeatedly, then snap the board, but this works best on thin planks.
Which blade is best for cutting laminate with a circular saw?
A fine-tooth blade with 60 or more teeth, often labeled for laminate or finish work, gives the cleanest edge. Check the blade packaging for the material it is rated for.
Do I need to wear protection when cutting laminate?
Yes. Wear safety glasses and a dust mask, since cutting produces fine particles. If you have questions about dust exposure, consult a professional.
Conclusion
For straight cuts on most rooms, a manual laminate cutter is often enough. Add a fine-tooth saw for notches and curves. Plan your layout, cut from the right side and dry-fit every piece before you commit.

